Wire The Fan And Wall Controller; Install The Airfoils; Position Airfoils - BIG ASS FANS 2025 Manuel D'installation

15. Wire the Fan and Wall Controller

WARNING: To reduce the risk of electric shock, wiring should be performed by a qualified electrician!
Incorrect assembly can cause electric shock or damage the motor and the controller!
Make sure power wiring is routed to the installation site. Minimum supply circuit size is 10 A @ 110–125 V, 1 Φ. See
Wiring Diagrams & Electrical Guidelines in the following section for instructions and guidelines on wiring your fan.

16. Install the Airfoils

WARNING: Disconnect power to the fan before installing the airfoils.
A. Attach airfoil tips to airfoils
Attach an airfoil tip to each airfoil using the Airfoil Tip
Hardware as shown. Securely tighten the screws using
a 3 mm allen wrench. Attach airfoil tips to all six airfoils
before attaching the airfoils to the fan.
Airfoil Tip Hardware:
a. (6) M5 x 12 mm Button Head Screw
B. Position airfoils
Slide the airfoils onto the tabs of the fan hub as shown.
20
WWW.BIGASSSOLUTIONS.COM © 2015 DELTA T CORP.
a
ALL RIGHTS RESERVED.