Install The Cover Plate; Install The Lower Cover Mounting Bracket - BIG ASS FANS 2025 Manuel D'installation

10. Install the Cover Plate

Plug the remaining male wiring harness from the fan into the
female wiring harness on the cover plate as shown.
Ensure all wiring is tucked inside the extension tube, and then
attach the cover plate to the extension tube using the Cover
Plate Hardware as shown.
Cover Plate Hardware:
a. (2) 8-32 x 1/2" Flat Head Screw

11. Install the Lower Cover Mounting Bracket

Remove the protective plastic cover from the bottom of the main fan unit and ensure that the three stator
wires on the bottom of the main fan unit are tucked in securely before installing the mounting bracket. Be
careful not to damage the stator wires while installing the mounting bracket and lower cover.
WARNING: Disconnect power to the fan before installing the lower cover mounting bracket and lower
cover.
Attach the lower cover mounting bracket
to the bracket on the bottom of the main
fan unit using the Lower Cover Hardware
as shown. Loosely attach all three screws,
and then tighten them.
Lower Cover Hardware:
a. (3) 8-32 x 3/8" Pan Head Screw
ATTENTION
WWW.BIGASSSOLUTIONS.COM © 2015 DELTA T CORP.
a
ALL RIGHTS RESERVED.
a
17