Starting The Pump; Starting The Fan - BIG ASS FANS COLD FRONT 100 Manuel De Fonctionnement Et D'entretien

Prolonged use of hard water without proper water treatment will create
mineral deposit buildup. This will cause the pump to fail and is NOT
COVERED BY WARRANTY.

Starting the pump

On initial startup, the cooling media in your new cooler will take a few hours to
become fully saturated. During this time, the media may produce an odor. This
odor will dissipate over time. For best results, change the water in the reservoir a
few times.
Subsequent startups
On subsequent startups, turn on the pump, start the fan, and cool down.
Low water indicator
The cooler is equipped with a low water indicator light.
♦ When the power is on and there is sufficient water in the reservoir, the light will
be green and the pump will be running.
♦ When the power is on and the water in the reservoir is low, the light will be red
and the pump will stop running.

Starting the fan

Turn the fan control knob clockwise to turn on the fan and adjust the speed to
your preferred setting.
4
WWW.BIGASSFANS.COM
CAUTION
© 2020 DELTA T LLC ALL RIGHTS RESERVED.