Operating The Fan; Changing The Fan Direction - BIG ASS FANS 2025 Manuel D'installation

To start the fan, press the control knob on the wall controller. Note: The LED
indicator at the top of the controller is lit when power is applied. The LED
indicator will flash an error code if there is a problem with the fan. See the
Troubleshooting section for LED error codes.
To stop the fan, press the control knob.
To increase fan speed, turn the control knob clockwise toward
To decrease fan speed, turn the control knob counterclockwise toward
Note: The fan may take 30–60 seconds to start rotating after it is turned on.
It is normal to see an initial slight jerking forward and backward upon startup
as the fan positions itself relative to the motor stator.

Changing the Fan Direction

Big Ass Fans recommends operating the fan in the forward (FWD) direction. The fan should be rotating
counterclockwise when viewed from below.
To reverse the direction of the fan, remove power from the fan. Select the direction of the fan using the fan
direction selector switch located on the fan's cover plate. Reapply power to the fan. For fan status LED definitions,
see the Troubleshooting section.
24

OPERATING THE FAN

ATTENTION
Fan Direction
Selector Switch
Fan Status
LED
WWW.BIGASSSOLUTIONS.COM © 2015 DELTA T CORP.
LED Indicator
.
.
Cover
Plate
ALL RIGHTS RESERVED.