Tips And Advice On Operation - SOMFY Sonesse 28 WireFree RTS Li-ion Notice

EN

3.7. TIPS AND ADVICE ON OPERATION

Observations
The driven product does
not operate.
The driven products
stops before its end limit
3.7.1. Adding/Deleting Control point
Orange LED blinks slowly when adding or deleting remote control.
Using a control point (A) that has been previously programmed to the driven product:
1) Press and hold the control point programming button (A)
until driven product briefly moves Up and Down. Green LED
blinks 5 times then orange LED blinks slowly.
2) Quickly press the programming button on the back of the
new control point (B) to add or delete control point and green LED blinks 5 times.
Using the Programming button on motor head:
1) Press and hold the motor head programming button until
driven product briefly moves Up and Down. Green LED
blinks 5 times then orange LED blinks slowly.
2) Quickly press the control point programming button (B) to add or delete control point and green
LED blinks 5 times.
3.7.2. Disabling/Activating "RTS" radio technology when control point is
definitively is programmed
Disabling the radio transmission saves battery life during shipment or for a long period of non-use
(eg storage). The following steps can only be performed in "User" mode.
Press and hold the programmed control point programming button or the motor head programming
button until the driven product briefly moves Up and Down and
green LED blinks 5 times. (Motor is in programming mode)
TO DEACTIVATE RTS RADIO TECHNOLOGY:
a) Press the UP, MY and DOWN simultaneously until the driv-
en product briefly moves UP and Down once and green LED
blinks 5 times.
TO ACTIVATE RTS RADIO TECHNOLOGY:
b) Briefly press the motor head programming button or plug in
the charger, the driven product briefly moves UP and Down
once and green LED blinks 5 times.
10
Possible causes
The control point battery is
low. LED doesn't light when
any button of a paired control
point is pressed.
Drive battery is low and
requires charge. Red LED
blinks 5 times when any
button of a paired control point
is pressed.
RTS is deactivated. LED
doesn't light when any button
of a paired control point is
pressed.
Thermal protection of the drive
is on (Red LED blinks slowly).
The drive has detected an
obstacle (solid Red LED).
Copyright 2017 - 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
Sonesse 28 WireFree RTS / Sonesse ULTRA 30 WireFree RTS
Change control point battery as required.
Plug in the charger.
Press motor PROG. button.
Wait for the motor to cool down (Red
LED will stop blinking when drive is
ready to use.
Move the driven product in the other
direction.
1
PROG.
A
1
PROG.
a
Solutions
2
PROG.
B
2
PROG.
B
b