Work Area; Safety Features - JAC VARIA Mode D'emploi

6 Advanced settings. This button accesses the slicer cleaning mode (n°38) and the Easymode
settings (n°42).
7 Accessing Easymode. Easymode is a screen configuration that enables you to save 6 quick
start buttons (n°40) which combine speed and cut thickness. To configure these buttons, press
the "advanced settings" button (n°33), followed by the "Easymode settings" button (n°42). All
you need to do then is to select a cut thickness and a speed for each of the 6 buttons (n°43)
by directly pressing the values you want to change. Exit the screen to confirm your selections.
If your slicer has the self VMS configuration, the touch screen consists of the following elements:
8 Cut thicknesses
9 Instructions for the consumer
10 To access the slicer settings, press and hold one of the cut thicknesses for 5 seconds. You will
then have access to two buttons (n°38 and n°39).
11 Running cleaning mode. Once this mode has been selected, you will be asked to enter code
0123 in order to unlock the cleaning mode start-up.
12 Cut thickness configuration. On this screen, you can set (n°44) a slice thickness for each of
the three buttons.
6.2

Work area

The work area is at the front of the machine (fig.3, n°18).
6.3

Safety features

This machine is equipped with:
An encoded magnetic safety switch (fig.6, n°19, 20)
Comprising a safety cut-out magnet and a magnetic sensor, which stops the machine when the front
door is opened (fig.1, n°10).
An encoded magnetic safety switch (fig.6, n°22)
Comprising a safety cut-out magnet and a magnetic sensor, which prevent the machine from starting
when the cover is opened (fig.1, n°1).
A mechanical safety lock (fig.6, n°21)
Which prevents the cover (fig.1, n°1) from being opened while the machine is in operation.
Caution: never start the slicer if any part of the exterior has been removed allowing
access to the blade or rotating drive components.
11
English