Commissioning; Danger; Controls And Safety Features; Controls - JAC Varia Pro Notice D'utilisation Originale

5.4

Commissioning:

Before commissioning, ensure that there are no extraneous objects interfering with the machine's
moving parts.
Ensure first of all (after verifying electric compatibility) that the motor is rotating in the right direction. If
the blade stops in the cutting channel and the machine goes into error mode, disconnect immediately
and switch two phase wires in the plug.
For machine operation, please refer to the "Operation" chapter.
5.5

Danger:

If the user or the machine is in danger, you must use the main isolator switch to cut the power supply
to the machine.
Remove the plug from the power socket before any maintenance and/or servicing work;
Do not touch the blade, even if it is stationary.
To replace the blade, have the work done by your approved dealer.
Always wear cut-resistant gloves when replacing the blade or when working in the vicinity of the
blade.
Any maintenance work or replacement of parts must be carried out by a qualified individual.
6

CONTROLS AND SAFETY FEATURES

6.1

Controls:

Your slicer is equipped as standard with a mechanical keyboard (fig.5).
As an option, it may be fitted with a touch screen (fig.6).
6.2

Work area:

The work area is at the front of the machine (fig.3, n°20).
6.3

Safety features:

This machine is equipped with:
An encoded magnetic safety switch (fig.8, n°21,22).
A magnetic sensor
Which stops the machine when the front door (fig.1, n°10) is opened using the lock (fig.1, n°9).
An encoded magnetic safety switch (fig.8, n°24).
A magnetic sensor
Which prevents the machine from starting when the cover is opened (fig.1, n°1).
A mechanical safety lock (fig.8, n°23)
Which prevents the cover (fig.1, n°1) from being opened while the machine is in operation.
English
10