Commissioning; Hazard; Controls And Safety Devices; Controls - JAC VARIA Mode D'emploi

This pictogram indicates an electrocution hazard. Please isolate the machine
before carrying out any work on it. You will find this pictogram at the back of the
machine and inside the machine on the electrical enclosure (fig.8, n°25).
You will find the circuit diagram for the machine on the back of the electrical
enclosure door (fig.8, n°26).
5.4

Commissioning

Before commissioning, ensure that there are no extraneous objects interfering with the machine's
moving parts.
For machine operation, please refer to the "Operation" chapter.
5.5

Hazard

If the user or the machine is in danger, use the main isolator switch to cut the power supply to the
machine.
Remove the plug from the mains socket before any maintenance and/or servicing work.
Wear gloves for any maintenance or cleaning work by the blade.
To replace the blade, have the work done by your approved dealer.
Be sure to wear cut-resistant gloves always when replacing the blade or when working in the vicinity
of the blade.
Any work involving maintenance or replacement of parts must be carried out by a qualified individual.
This pictogram indicates a cut hazard. You will find this pictogram at the back of
the machine close to the power cable (fig.8, n°27) and inside the machine on the
blade guard (fig.1, n°6).
6

CONTROLS AND SAFETY DEVICES

6.1

Controls

Your slicer is fitted with a touch screen (fig.9).
If your slicer has the pro VMP – VMA configuration, the touch screen consists of the following
elements:
1 Slice thickness
2 Number of slices
3 Cutting speed
4 Choice of 4 cutting modes:
a. Cut whole loaf,
b. Cut a number of slices,
c. Cut half the loaf into slices,
d. Cut loaf in half,
5 Start cutting
English
10