BRP EVINRUDE E-TEC G2 Guide page 3

6 Includes timing verification.
7 Add 1.0 for counter rotation models.
8 Flat rate time includes removal of lower engine covers.
9 Flat rate time includes removal of oil reservoir. Add 0.5 for removing lower covers (H101) for bottom injector only.
Use failing part number 8888885 for software updates unless the EMM software update is being performed as a result of
a specific warranty bulletin. Refer to the applicable warranty bulletin for unique failing part numbers related to specific
10 warranty campaigns.
Replacement Item Only – Contact After Sales Support – Tech Service.
11
12 Includes Remove & Replace engine covers and frames
13 Includes R&R of Gearcase assembly
14 Install new shift lever and cradle
15 Includes allowance time for assistance from second technician
16 Includes steering system bleed
17 Add .4 hrs. for E-link module replacement
3
. JOB REQUIREMENTS
All the flat rate times mentioned in the following pages include the required operations such as: engine
timing, connecting rod(s) alignment, cylinder head(s) torque or use of parallel bar, use of ignition
tester, piston clearance/ring end gap measurement, crankshaft to crankcase measurement, cylinder
honing, and engine leak test.
4. REQUEST FOR REVIEW OF FLAT RATE TIME STANDARD
This form is for your convenience to request a review of an established Flat Rate Time Standard. The
information you provide will assist in our efforts to pay for warranty work fairly. Thank you for your
help.
Engine Covers and Frames (SAP System Code 28)
DESCRIPTION
Top, Front, Rear, Port, or Starboard Engine
Cover
All Engine Covers
Port or Starboard Side Frame (includes
engine covers) – one
Port and Starboard Side Frames (includes
engine covers) – both
Front (Motor) Frame (includes engine covers)
Center Frame (includes engine covers)
Decal application
Rigging Center
NOTE NOTE
74°V6 66°V6
1 1
1 1
1 1
1 1
1 1
1 1
16 16
3
CODE CODE
74°V6 66°V6
C402 C402
C403 C403
C404 C404
C405 C405
C406 C406
C407 C407
C408 C408
C409 C409
TIME TIME 66°V6
74°V6
0.1 0.1
0.3 0.3
0.5 0.5
0.7 0.7
1.0 1.0
2.5 3.0
0.2 0.2
1.0 1.0