BRP EVINRUDE E-TEC G2 Guide page 2

INTRODUCTION
This manual provides Warranty Flat Rate Allowances for Evinrude
manual can also be useful in determining shop hours required to perform non-warranty service work or
maintenance.
1. HOW DOES IT WORK
Follow the procedures detailed in the Evinrude E-TEC G2 Service Manual. The flat rate time is the
maximum time allowed for a repair involving any given part. FLAT RATE TIME IS NOT CUMULATIVE.
You must use the flat rate time given for the longest lasting operation. All flat rate times are based on
the actual time required for a factory trained technician to complete the various operations using the
appropriate tools and Evinrude E-TEC G2 special tools. All fractions of hours are in tenths
2. COMPILATION
Flat rate times include an allowance for diagnosis as well as time for the removal and
replacement of all components necessary to complete the repair. Where appropriate, the flat
rate times also include time for performance tests with recommended test equipment. Flat rate
times are not cumulative. Only use the flat rate time for the longest operation. Be aware of this when
comparing flat rate hours claimed and those paid. If Flat Rate times overlap, this extra time will be
cut from the claim without notification. Flat rate times do not include the additional work required
for removal of corroded screws. Dealers in salt water areas may add this time, when appropriate. See
flat rate codes "Y" for additional allowances. Only one salt water allowance may be submitted for each
major repair. Any additional time required due to corrosion will be the responsibility of the customer.
See applicable Evinrude E-TEC G2 Limited Warranty.
The Flat Rate Time Schedule is compiled as follows:
The actual time required to perform the repair plus (+) 30% correction factor up to 3.0 hours or (+) 15%
over 3.0 hours' time to consider, among others:
•
Vehicle handling
•
Obtaining the parts
•
Diagnosis
•
Cleaning
•
Special compensation (rusted bolts)
NOTE CODES
Details for specific repair procedure:
Authorization required prior to repair/ordering parts for repair – contact After Sales Support.
1
2 Includes return packaging.
3 Contact dealer services for assistance.
4 When servicing or replacing two or more components, call for prior authorization.
See Note 12 for 115 – 300 G2 engine covers and frames. Add 0.5 (H101) for lower engine cover removal when replacing
5 injector/coil assembly on bottom cylinder(s) or replacing lower tube assembly 30-90 HP G1.
®
2
G2™ outboards. This
®
E-TEC
.