Console Display And Mode Key (14:D; 15) (Mod. 740 Iox, 540 Ix); Rear Accessory And Headlamps Control (14:D; 15) (Mod. 340 Ix); Hour Meter Display (14:D; 15) (Mod. 340 X) - Stiga Park 4WD Serie Manuel D'utilisation

EN
6 .10 CONSOLE DISPLAY AND MODE KEY
(14:D; 15) (Mod. 740 IOX, 540 IX)
MODE key (14:E) . With the MODE key it is
possible to select the indicator lights cor-
responding to the functions: hour meter,
ambient temperature, engine revs, batte-
ry . It is possible to force headlamp use by
excluding the twilight sensor .
• Briefly press and release the key to ac-
cess the display indicators correspon-
ding to the various functions in succes-
sion. On the alphanumerical digits on
the display the data associated with the
selected icon is displayed, the last figure
is reserved for the unit of measurement.
• Press for more than 1 second to turn on
or off the headlamp.
Automatic headlamp control is automa-
tically restored each time the machine
is turned on .
Digits (15:A) . Part of the display which
provides alphanumerical data corre-
sponding to the various functions .
Hours meter (15:B) . The alphanumeri-
cal digits indicate the number of hours
the machine has been driven, divided
into hours and tenths of hours . It is acti-
ve only when the engine is running . The
unit of measurement is followed by the
letter H .
Ambient temperature (15:C) . The alpha-
numerical digits indicate the ambient tem-
perature. The unit of measurement is follo-
wed by the letter C.
Revs counter (15:D) . The digits indicate
the number of motor revs. When flashing it
indicates the engine speed, with the PTO
active, is not optimal (over 2500 rpm). Take
the accelerator command to full throttle.
Service (15:E) . Provides maintenance
indications. The figures on the digits start
flashing when the machine has reached the
service time threshold.
Flashing will continue for two minutes and
overrides the other functions on the display.
In this phase the MODE key is disenabled.
When the hour meter reaches 99999 it re-
turns to zero. After 999 hours, the minutes
count is dropped.
14
ENGLISH
Battery (15:F) . The alphanumerical digits
indicate battery voltage.
Power take-off (15:G). If the indicator light
is on it means the PTO is active.
12V ON/OFF (15:H) . If the indicator light is
on it means the rear accessory is active.
Headlamp (15:l) . If the indicator light is on
it means that the headlamp, usually control-
led by a twilight sensor, is switched on.
Maximum tilt (15:L) . The indicator starts
to flash if machine tilt exceeds the 10° th-
reshold.
In the event of sensor malfunction the
message "TILT FAULT" appears.
Parking brake pedal (15:M) . If the indica-
tor light is on it means that the parking brake
is on.
Seat (15:N) . If the indicator light is on it me-
ans the driver is not seated.
Oil (15:P) . If the indicator comes on while
the machine is in operation it means the oil
is low.
6 .11 REAR ACCESSORY AND HEADLAMPS
CONTROL (14:D; 15) (Mod. 340 IX)
Headlamps/12V button (14:E) Pressing
the headlamp/12V button activates the
functions to turn on the headlamp and
activate the rear accessory .
When the command is enabled, the
round LED around the button lights up .
• Quickly press and release to turn the he-
• Press the button for more than 1 secon-
6 .12 HOUR METER DISPLAY (14:D; 15) (Mod.
340 X)
Hour meter display (15:B) . The alphanu-
merical digits indicate the number of hours
the machine has been driven, divided into
hours and tenths of hours. It is active only
(Translation of the Original Instructions)
adlamp on/off manually. If the control is
enabled, the LED just above the button
comes on.
ds to activate/deactivate the rear acces-
sory. If the control is enabled, the LED
just below the button comes on.