Information Display Messages (Mod. 740Iox; 540Ix); Troubleshooting - Stiga Park 4WD Serie Manuel D'utilisation

(Translation of the Original Instructions)
Replace the air pre-filter
Clean the air filter
Replacing the air filter
Replacing the spark plugs
Clean the engine air intak
*** Interventions which must be carried out by your dealer or an authorised assistance centre
(1) 50 hours for original black B&S filters - 100 hours for high efficiency yellow B&S filters.
(2) Clean more frequently when operating in particularly demanding conditions or when there is debris in
the air.
14 INFORMATION DISPLAY MESSAGES (Mod. 740IOX; 540IX)
MESSAGE
CHECK CONNECTION
NO MOVING
START ENGINE
PRESS BRAKE
SIT DOWN
TILT FAULT
PROBLEM
ENGLISH
-
ACTION / POSSIBLE CAUSE
An attempt has been made to start the
rear accessory (14:L). No accessory is
connected to the socket (17:A).
The plug is connected to the socket
but the message persists.
An attempt has been made to adjust
the rear accessory (14:I; 14:H). No ac-
cessory connected to the socket (17:B).
The plug is connected to the socket
but the message persists.
An attempt has been made to engage
the PTO with the engine switched off.
An attempt has been made to start
the engine with the parking brake off.
An attempt has been made to start the
engine with no-one in the driver's seat.
Tilt sensor malfunction.
This text runs twice:
- when the clinometer fails.
- each time the machine is started up,
after the initial indicator check runs on
the display

15 TROUBLESHOOTING

PROBABLE CAUSE
25 hours
100 hours
400 hours /
every season
100 hours /
every season
8 hours /
every season
REMEDY
Connect the plug on the accessory
to the socket on the machine.
Contact an authorised assistance
centre.
Connect the plug on the accessory
to the socket on the machine.
Contact an authorised assistance
centre.
Start the engine.
Put the parking brake on.
Sit in the driver's seat.
Contact an authorised assistance
centre.
REMEDY
EN
9.10.3 (2)
9.10.3 (2)
9.10.3
9.10.4.
9.10.5
25