f) Introducing the distance for the tachymeter
To enable the tachymeter to calculate the speed correctly, the distance corresponding
to the time recorded must be introduced. This setting is done as follows:
• With
mode stopped without displaying the speed, pull the crown into
CHR ADD
position 2; the upper screen will display
distance), followed by one to three letters (for the distance unit); the distance
unit flashes.
• Select the distance unit by turning the crown – see figure 2:
Distance unit
(meter)
M
(kilometer)
KM
(foot)
FT
(yard)
yD
(mile)
MI
(nautical mile)
NMI
, followed by 3 digits (for the
DIST
Corresponding speed unit
(meters per second)
M/S
(kilometers per hour)
KM/H
(feet per second)
FT/S
(yards per second)
yD/S
(miles per hour)
MPH
(knots)
KNoT
Figure 2
112
•
Confirm by pressing P2; the first digit of the distance value will flash.
•
Select the units, the tens and then the hundreds for the distance by turning the
crown, confirming each time by pressing P2.
•
Press the crown back to neutral position 1.
g) Rereading intermediate times
Rereading of intermediate times is achieved by successive pressing of P2 with
the display of
to
xx intermediate times memorized.
SPLIT01
SPLIT
h) Recovery of times
If the watch is connected to a smartphone, using the application on the latter
it is possible to recover information on times recorded.
i) Synchronizing the seconds hand
If the seconds hand does not position itself exactly on 0 in
as follows:
•
Pull the crown into position 2.
•
Press P1 to activate synchronization of the hand (
•
Turn the crown to reposition the hand on 0.
•
Press the crown into neutral position 1.
mode, proceed
CHR ADD
).
SyNCHRo
113