Breitling EXOSPACE B55 Mode D'emploi page 53

• If necessary, adjust the minutes in 15-minute increments and confirm by pressing
P2; the seconds flash ( appears on the upper screen).
SECoND
• Adjust the seconds (which will automatically be adjusted in the
and confirm by pressing P2.
• Press the crown back to neutral position 1.
N.B.: When in setting mode (
SETTIME
from 0. The seconds counter only stops when the seconds are manually modified.
In this case, it restarts when exiting setting (putting the crown back to neutral
position 1). The seconds are automatically synchronized on the
timezones.
In mode, pressing P1 makes it possible to go into
TIME
date according to different formats (see chapter 8). A long press on P1 puts the
display directly back to .
TIME
In mode, a long press on P2 allows to choose between either the 12-hour (
TIME
or indicator) or the 24-hour display. The change also happens automatically for
PM
the zone and the seven alarms.
TIME 2
TIME 2
), pressing P1 will restart the seconds counter
and
UTC
mode and display the
DATE
98
7. CONFIGURING THE wATCH (
In the
SETTING
and ) memorized by the watch and therefore available even in the event of the battery
UTC
being completely flat):
1.
SyNCHRo
2. : lighting goes on automatically (and possibly the LCD) depending on the
TILT
position of the wrist (positioned around 30° to horizontal), but for a maximum
of 30 seconds, unless in the setting mode (
3. : setting the duration for the lighting to be switched on when the crown
TIME 2 LIGHT
is pressed.
4.
DISPLAy
lighting or readable only with lighting.
5.
NIGHT MoDE
the
AM TILT
hand, this function makes it possible to reduce consumption and on the other,
to avoid the lighting being too bright in the dark.
6. : audible confirmations connected to pushpieces, with or without hourly
ToNE
time signal or signal for full timekeeping hours.
7.
HANDPRK
press on the crown.
)
SETTING
mode, the following adjustments can be made (all these settings are
: synchronization of the analog display with the digital display.
SETTING
: choice of digital LCD behavior – readable all the time even without
: Option of reducing the light intensity to a minimum and disabling
mode as well as notifications between 24:00 and 06:00. On the one
: exit parking the hands mode after 5 minutes or simply with a double
99
).