Breitling EXOSPACE B55 Mode D'emploi page 50

guaranteeing the contact and a mechanical alignment system. As soon as the
contact is made, the watch confirms with a beep sound and a luminous flash
on the LCD display. If the hands were stopped, they will adjust to the right time
and the word will appear in the upper screen.
CHARGE
Once the battery is fully charged, the upper screen will display
watch will give off a luminous flash. A full recharge takes around 2 hours.
Once the watch is disconnected from the charger cable (
upper screen), three things may happen:
1. The watch will function as usual and no action is required.
2. The watch was in sleep mode or not completely flat: in principle, nothing needs
to be done, but for safety's sake, the initialization procedure should be conduc-
ted in order to confirm the different states (see chapter 3).
3. The watch was completely flat and must be initialized (see chapter 3).
and the
BAT 100%
appears in the
UNPLUG
92
NOTE: To recharge your watch, please use the cable supplied with the trans-
former.
The cable, can, however be used directly on a USB port on a PC/Mac. In this
event, please note that the short-circuit-proof protection of a USB port on PC/
MAC or on a portable computer differs from one device to another.
In order to avoid any possible issues occurring from faulty electric contacts
during recharging, we recommend cleaning the contacts on the watch before
recharging it. Using a soft cloth to do this (without any special cleaning agent)
is adequate.
Please take care not to short-circuit the two contacts on the recharging cable
and in particular, never place the ends of the cable on metallic surfaces.
3. INITIALIZING THE wATCH
When used for the first time, or after having been charged, the watch guides the
user though the following sequence:
1. Pull the crown into position 2 (
PULL CRoWN
function.
2. Synchronize ( ) the hour, minute and seconds hands with the digital
SyNCHRo
display (see chapter 7.a).
) in order to activate the settings
93