Breitling EXOSPACE B55 Mode D'emploi page 46

The crown can be turned forwards (clockwise) or backwards (anti-clockwise).
If one forgets the crown in the pulled out position, the upper screen will display
at regular intervals, while a beep will sound every 30 seconds.
PUSH CRoWN
A short press on the crown will light up the two digital displays. If the
function has been activated (see chapter 7.b), the light will automatically
switch on depending on the position of the wrist.
The watch has two pushpieces (P1 at 2 o'clock and P2 at 4 o'clock), whose action
is connected to the function selected. Depending on the desired action, the user
must give a short or long (about 2 seconds) press. If no action is associated with the
pushpieces, will appear in the upper screen.
NoP
: indicates that the watch is in the process of calculating.
WAIT
(overflow) indicates that a counter limit has been exceeded.
oVF
d) Light intensity setting
A long press on the crown activates the light intensity setting mode. This setting
takes place by turning the crown:
LIGHT
x – x which represents the level from 1 to 4. The new setting must be confirmed
/4
by a short press of the crown. After 10 seconds, the watch automatically exits the
setting function.
will appear in the upper screen, then select
84
The higher the figure, the greater the light intensity. Bear in mind that the greater
the light intensity, the more battery is used, which will result in shorter autonomy
(see chapter 2).
e) "Parking" the hands
TILT
A double press on the crown allows the hour and minute hands to be "parked" (at
09:14 or 02:46) so as not to affect the readability of the two digital displays. The
seconds hand continues to move forward as usual. In this mode, all digital functions
remain perfectly functional. By default, the hands can only move out of parking
mode after a second double press. There is however an option that allows them to
move forward automatically after 5 minutes (see chapter 7.g).
The hands are automatically "parked" when the crown is pulled out to
mode.
f) Blocking a function
Should you wish to keep a specific function displayed, this can be done by
deactivating the crown rotating function in neutral position. In order to do this,
push the crown three times. The word
for around 2 seconds. From now on, the selected function will remain displayed
until you push the crown three times again (and
at 12 o'clock). If the crown is turned in "locked" mode, the word
at 12 o'clock for 2 seconds.
will appear in the screen at 12 o'clock
LoCKED
will appear in the screen
UNLoCKD
will appear
LoCKED
85
SETTING