Breitling EXOSPACE B55 Mode D'emploi page 59

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

b) Measuring a period with intermediate/split time(s)
• Pressing P1 starts the chronograph. The upper screen displays
lower screen the hours, minutes and seconds up to 99 hours, 59 minutes and
59 seconds.
• Pressing P2 will display the intermediate time. The upper screen displays
th
alternating the 1/100
of a second; the timing continues in the background. The
time remains flashing for ten seconds after which the display switches to the
total time being recorded.
• Repeat again for xx intermediate times (
• Pressing P1 stops the chronograph (display on the upper screen:
th
nating with the 1/100
of a second).
• Pressing again on P1 restarts the chronograph.
• A long press on P2 will reset the chronograph to zero as well as all the interme-
diate times (
).
RESET
If one forgets to turn the timing off, when the total time reaches 99 hours, 59
minutes and 59 seconds, measuring ceases and the upper screen displays
(for overflow).
CHR RUN
SPLIT
xx) up to a maximum of 50 times.
SPLIT
CHR ADD
110
c) Flyback
At any time, a long press on P1 will restart timing from 0 (when the pushpiece is
, the
released): this is the
the active timing second. The
times that have already been recorded.
xx
d) Tachymeter
When the chronograph has been stopped after a measured time without an inter-
mediate time, a short press on P2 will display the average speed corresponding
to the total time measured – for a pre-introduced distance (see chapter 10.f). The
upper screen displays
value of the speed. The display of the speed lasts about 5 seconds and then reverts
alter-
to the preceding display.
e) Converting units of speed
When the speed is displayed, the unit can be changed, thus converting it, as follows:
• When the speed appears, pull the crown to position 2 (
• Change the units by turning the crown (see figure 2)
oVF
• Press the crown into neutral position 1. The speed is automatically expressed in
the new unit.
function. The seconds hand positions itself directly on
FLyBACK
function results in the loss of all intermediate
FLyBACK
, and then the speed unit; the lower screen shows the
SPEED
111
)
CoNVERT

Publicité

Chapitres

Table des Matières
loading

Table des Matières