1 GENERAL INFORMATION
1.1 Symbol used
The following symbols are used in these operation instructions:
marks a working step that you must carry out.
ATTENTION!
NOTE
1.2 Intended use
The device is designed only for use as an electromotive rotary on/off actuator or
control actuator for ball or flap valves. Any other use is not considered the intended
use. Bürkert is not responsible for any damages resulting from such use. The user
bears all risk.
The safety features of the device may not be defeated under any circumstances. All
accident protection guidelines must be obeyed at all times.
Unauthorized rebuilding or changes to the device are not allowed for safety reasons.
When exchanging parts due to failure or normal wear, use only original replacement
parts.
The operating instructions in the individual chapters must be followed and the safety
tips be obeyed at all times. If the operating instructions, safety tips, or safety informati-
on are ignored or not followed in the proper order, the warranty shall be void.
Read the operating instructions carefully. In particular, follow the chapter „General
safety information."
The operating manual describes the entire life cycle of the device. Therefore, take care
to keep the manual and make it accessible to the appropriate device users
Indicates information that must be followed. Failure to do this could
endanger your health or the functionality of the device..
Indicates important additional information, tips and recommen-
dations..
3003 - 3