Returning From Manual To Automatic Operation - Burkert 3003 Instructions De Service

5.2 Returning from manual to automatic operation

To switch back into automatic operation, turn the knob to „AUTO" and the drive shaft
to the „closed position" (Work steps: see Figure 10).
Turn the knob from "MAN" to "AUTO".
Remove the position indicator from the cover.
Use a wrench to turn the setting pin of the drive shaft to the "CLOSED
POSITION".
Replace the position indicator. (The marking should now show the "CLOSED
POSITION".
Type 3003 actuator on open position:
Actuator 20 Nm
Cover
for automatic
operation, turn
"AUTO" marking to top
Fig 11: Returning the actuator from manual to automatic mode.
18 - 3003
Position indicator
wrench
OPEN POSITION
CLOSED POSITION
Housing