Burkert 3003 Instructions De Service page 16

DC connections (see Figures 6 and 7)
Poles connect
+
–
bridge
NOTE
Connection of control card for variants with analog inputs
Poles/leads
TE Ground (yellow-green)
–/N Minus pole or neutral
+/Ph Plus pole or phase
Poles
+ Input
– Input
Output
+
Output
–
Thighten the plug screws after connecting the terminals as shown in the
corresponding table
Set the cover in place and screw it tight.
Reinstall the position indicator.
14 - 3003
to
Terminal 1
Terminal 2
Terminal 2 and 3
Exchange connections 1 and 2 if opening and closing do not
function properly.
Power supply DC / AC
Connection of input or output signal
4-20 mA
connect to
Cable socket
Terminal 18
Terminal 17
connect to
Terminal 16
Terminal 15
Terminal 13
Terminal 14