SOMFY ROLLIXO io Manuel D'installation page 32

Rollixo io
Checking the direction of rotation of the motor and adjustment of the motor end limits
[1]. Press simultaneously on the
down movement occurs to enter motor adjustment mode.
Indicator light 1 flashes slowly.
[2]. Press button or to check the motor's direction of rotation.
• If the motor's direction of rotation is correct, move on to step [3] of the
motor end limit setting procedure.
• If the direction of rotation is incorrect, press button
motor's up and down movement occurs, check the motor's direction
of rotation again and move on to step [3] of the motor end limit setting
procedure.
[3]. If the motor end limits are already set, move on to step [8] to exit motor
adjustment mode.
If the motor end limits are not set, check that the motor is released: the
two push-buttons should be pressed.
Note: The motor end limits can also be set with a setting tool (ref. 9015971).
In this case, set the motor end limits with the cable then move on to
step [8] to exit motor adjustment mode.
[4]. Press button to position the garage door in the upper position.
Adjust the top position with buttons
[5]. Press the motor's upper end limit push-button.
[6]. Press button
to position the garage door in the lower position.
Adjust the bottom position with buttons
Copyright © 2012 Somfy SAS. All rights reserved
and buttons until the motor's up and
until the
STOP
and .
and .
1 2 3
STOP
1 2 3
STOP
Correct direction
of rotation
on
1 2 3 4
1 2 3 4
Prog
STOP
1 2 3 4
STOP Prog
Prog
STOP
or
1 2 3 4
1 2 3 4
Prog
STOP
1 2 3 4
STOP Prog
Prog
STOP
4
Prog
4
Prog
Incorrect direction
of rotation
1 2 3 4
Prog
STOP
7