Installing The Safety Edge And Its Transmitter; Recognising Magnets - SOMFY ROLLIXO io Manuel D'installation

Rollixo io
[2]. Fix the upper magnet to the edge of the runner, observing a distance of
70 mm between the base of the transmitter and the top of the magnet.
This operation is important. Ensure the dimensions are observed.
[3]. Press button
to position the garage door in the low position.
[4]. Attach the magnet to the edge of the runner, positioning it in line with the
transmitter.
This operation is important. Ensure the alignment is observed.
[5]. Press button then stop the door by pressing button
garage door in the intermediate position.

Installing the safety edge and its transmitter

Follow the instructions provided with the resistive safety edge transmitter (ESE) and the safety edge lengthening kit.

Recognising magnets

It is essential that the following procedure is observed to ensure
completely safe operation of the door.
The door must be in the intermediate position before the magnet
recognition procedure can be started.
Do not press the safety edge during the magnet recognition
procedure.
Carry out two whole cycles (opening then closing) using buttons
10
STOP
STOP
STOP
STOP
STOP
to position the
STOP
STOP
STOP
STOP
and .
STOP
STOP
10 mm maxi.
1 2 3 4
Prog
1 2 3 4
Prog
1 2 3 4
Prog
1 2 3 4
Prog
10 mm maxi.
1 2 3 4
Prog
1 2 3 4
Prog
1 2 3 4
Prog
1 2 3 4
Prog
1 2 3 4
Prog
1 2 3 4
Prog
Copyright © 2012 Somfy SAS. All rights reserved
70 mm
TOP
magnet
BOTTOM
magnet