Victron energy VE.Bus BMS Manuel page 8

Masquer les pouces Voir aussi pour VE.Bus BMS:

Les langues disponibles

Figure 7: System for a boat or vehicle with inverter/charger

Note: the BMS is connected to the battery minus by the UTP cable between the BMS and the inverter/charger.

Therefore, in order to prevent ground loops, do not wire the BMS minus connector.

Figure 8: System example for a boat or vehicle with a three phase inverter/charger configuration (DC fuses not shown, except

for the the Li-ion battery fuse)

Note 1: the AC Detector is installed only in the leader.

Note 2: the BMS is connected to the battery minus by the UTP cable between the BMS and the inverter/charger.

Therefore, in order to prevent ground loops, do not wire the BMS minus connector.