DBI SALA TALON 3101000 Manuel D'instructions page 8

2.4 ancHorage strengtH: In accordance with ANSI Z359.1,
anchorages selected for a fall arrest systems shall have a strength
capable of sustaining static loads applied in the directions
permitted by the system of at least: A) 5,000 pounds (22.2 kN) for
non-certified anchorages or B) Two times the maximum arresting
force for certified anchorages (see section 8 Terminology).
When more than one personal fall arrest system is attached to an
anchorage, the strengths previously set forth in (A) and (B) shall
be multiplied by the number of systems attached to the anchorage.
•
used for attachment of a personal fall arrest system shall
be independent of any anchorage being used to support or
suspend platforms, and must support at least 5,000 lbs.
(22.2 kN) per user attached, or be designed, installed, and
used as part of a complete personal fall arrest system which
maintains a safety factor of at least two, and is supervised by a
qualified person.
2.5 USING THE SRL WITH A HORIZONTAL SYSTEM: The SRL and
horizontal system components must be compatible. Horizontal
systems must be designed and installed under the supervision of a
qualified person (see section 8 Terminology).
3.0 INSTALLATION AND USE
WARNING: Do not alter or intentionally misuse this equipment.
Consult DBI‑SALA when using this equipment in combination with
components or subsystems other than those described in this manual.
Some subsystem and component combinations may interfere with the
operation of this equipment. Use caution when using this equipment
around moving machinery, electrical hazards, chemical hazards, and
sharp edges.
figure 4 - Inappropriate connections
From OSHA 1910.66 and 1926.500: Anchorages
8