Publicité
Les langues disponibles
Les langues disponibles
C .
SWIVEL EYE: See Figure 7. Attach the SRL to the anchorage
or anchorage connector by inserting a carabiner through the
swivel eye and around the anchorage or anchorage connector
[16 ft. (4.9 m) series only].
3.5 ATTACHING THE
srl to a fUll
BoDY Harness:
For models including
a quick-connect
attachment handle
only, and to be used
with DBI-SALA full
body harnesses only.
See Figure 8. To
attach the SRL directly
to a full body harness,
pass the quick-connect
attachment handle
through the same
loops as the existing
D-ring or connector. Connect the SRL hook or carabiner to a
suitable anchorage.
3.6
UsIng tHe srl: Connect the SRL to a suitable anchorage.
Connect the SRL hook or carabiner to the appropriate connector
on your full body harness. Ensure hook or carabiner is closed and
locked onto the harness connector.
note: Do not use the
following DBI-SALA
hooks and carabiners
to connect to your full
body harness: 2000108,
2007153, and 9510057.
See Figure 9.
When connected to the
SRL the worker is free to
move about within the
recommended working
area. The lifeline should extend and retract without hesitation or
creating a slack line condition as speeds. If a fall occurs the SRL
will lock and arrest the fall. When disconnecting from the SRL keep
the lifeline under control as it recoils back into the device. A tag
line may be required to extend or retract the lifeline.
3.7
IMPact InDIcator: See Figure 10. The SRL incorporates an
impact indicator in the lifeline. The lifeline web is folded over
and stitched with red thread. The stitched fold will pull out at
approximately 450 lbs. (204 kg) If the red stitching is intact the
SRL has not been impacted. If the red stitching is broken and
figure 8 - attaching srl to Harness
Figure 9 - Hooks
13
Publicité
