DBI SALA TALON 3101000 Manuel D'instructions page 16

Step 10. Record the inspection results in the inspection and
5.5 If the inspection reveals an unsafe or defective condition, remove
the SRL from service and contact an authorized service center for
repair.
NOTE: Only DBI‑SALA or parties authorized in writing may make
repairs to this equipment.
6.0 MAINTENANCE, SERVICING, AND STORAGE
6.1 MaIntenance:
a. HoUsIng: Periodically clean the exterior of the SRL with
water and a mild detergent. Position the SRL so water can
drain out. Clean the labels as required.
B. lIfelIne: Clean the lifeline with water and a mild detergent.
Rinse and thoroughly air dry. Do not force dry with heat. An
excessive build-up of dirt or other contaminants may prevent
the lifeline from fully retracting, causing a potential free fall
hazard. Return the SRL to an authorized service center for
lifeline replacement if necessary.
c. Personal fall arrest sYsteM coMPonents: Clean
and store associated system components according to
manufacturer's instructions.
6.2 serVIcIng: Do not disassemble the SRL. Do not lubricate any
part of the SRL. Additional maintenance and servicing must be
performed by an authorized service center. A return authorization
number must be issued by DBI-SALA. See section 5.2 for servicing
frequency.
6.3 storage: Store the SRL in a cool, dry, and clean environment,
out of direct sunlight. Avoid storing the SRL in areas where
chemical vapors exist. Thoroughly inspect the SRL after extended
storage.
7.0 SPECIFICATIONS
7.1 PerforMance sPecIfIcatIons:
• Capacity (All Models): 75 - 310 lbs. (34 - 141 kg), one
user only
• Working Range, 8 Foot Models: 2.5 ft. - 8 ft (.8 m - 2.4 m)
• Working Range, 16 Foot Models: 1.5 ft. - 16 ft (.5 m - 4.9 m)
• Maximum Arresting Force (All Models): 900 lbs. (408 kg)
when tested in accordance with ANSI Z359.1.
• Average Locking Speed (All Models): 4.5 ft./sec. (1.4 m / sec.)
• Maximum Arresting Distance (All Models): 42 in. (1 m)
maintenance log in section 10.0 or using the I-safe web
portal.
16