Publicité
Les langues disponibles
Les langues disponibles
figure 6 - connecting to the anchorage
3.4
connectIng to tHe ancHorage: When using a hook or
carabiner to attach to the anchorage, ensure roll-out cannot occur.
See section 2.3. Do not use a hook or carabiner that will not
completely close over the anchorage or anchorage connector. See
Figure 6. Follow the manufacturer's instructions supplied with each
system component.
a.
QUIcK-connect attacHMent HanDle: See Figure 7. To
open the quick-connect attachment handle, depress the locking
lever on top of the SRL. Pull the locking pin out to release the
handle. Swing the handle up to open. Place the handle around
the anchorage or anchorage connector. Swing the handle down
and realign the holes. Push the locking pin through the holes.
WARNING: Ensure the locking pin fully engages the handle and the
locking lever is in the locked position.
11
Publicité
