Wilo Stratos GIGA2.0-I Notice De Montage Et De Mise En Service page 166

en
WELCOME - WILO-STRATOS GIGA2.0
Start with factory settings
Pump operates for radiator
First settings
for commissioning
Fig. 31: Initial settings menu
10.4.4 Main menu
Radiator – Dynamic Adapt plus
Normal operation
Fig. 32: Main menu
10.4.5 Main menu "Home screen"
166
The pump has been • You can exit the initial settings menu by activating "Start with factory settings" menu.
successfully installed.
Pump is currently running in The display changes to the main menu. The pump continues to run using the factory set-
factory setting:
tings.
Application:
Radiator
• In the "Initial settings" menu, language, units and applications can be selected and adjus-
Control mode:
ted. The chosen initial settings are confirmed by activating "Finish initial settings". The
Dynamic Adapt plus
display changes to the main menu.
Quit the Initial settings menu to open the Home screen on the display and operate it from
the main menu.
Symbol
Duty point:
DA plus
Q = 13.0 m³/h
H = 2.6 m
Measured values:
T fluid = 70.9 °C
P electr. 202.0 W
4200.0 kWh
W electr. =
Further settings
Table 16: Main menu symbols
Setpoints can be changed in the "Home screen" menu.
The home screen can be selected
bol.
Pressing the operating button activates the setpoint adjustment. The frame of the change-
able setpoint turns yellow.
The setpoint is changed by turning the operating button right or left.
Pressing the operating button again confirms the changed setpoint. The pump accepts the
value and the display returns to the main menu.
1
Fig. 33: Home screen
Pressing the "Back" button
value and retains the old setpoint value. The focus returns to the "Home screen".
Installation and operating instructions • Wilo-Stratos GIGA2.0-I, Wilo-Stratos GIGA2.0-D • Ed.02/2022-07
Meaning
Home screen
Settings
Diagnostics and measured values
Restore and reset
Help
by turning the operating button to the "House" sym-
1.1
Radiator - Differential pressure Δp-v
Delivery head setpoint
1.0
6.1 m
Normal operation
3
during setpoint adjustment discards the changed setpoint
NOTICE
Setpoint adjustment is not possible when Dynamic Adapt plus is active.
2 6
Duty point:
6.9
Δp-v
12.0
Q = 10.3 m³/h
H = 2.0 m
Measured values:
T fluid = 68.2 °C
P electr. 160 W
= 42.0 kWh
W electr.
=
Further settings
4 5
7
8