Güde TK 2400 ECO Mode D'emploi page 30

Fig. 25
Fig. 26
Fig. 28
•
Fig. 22
•
Fig. 23
•
Fig. 24
•
•
•
•
•
Fig. 27
•
•
30
Put wrench 13 on the disc spindle .
Take the belt from the pulley using the screwdriver while turning
the disc spindle in the direction of the small pulley.
Turn until the belt is completely taken off the small pulley .
Now, take the belt off the big pulley.
Push the worn belt through the pulley and dispose of it in a
professional way. .
Push a new belt through the gap between the pulleys .
First, see to the motor belt wheel for the grooves to fit in correctly
.
Put wrench 13 on the saw spindle again .
Put the belt on big wheel now .
Turn the screwdriver very firmly in the direction of the belt pulley
.