Güde TK 2400 ECO Mode D'emploi page 24

Fig. 5
Structural group 5
Fig. 6
Initial Operation Safety Instruction
• Unplug the unit before any adjustment and maintenance .
•
Caution! Rotating saw disc may hurt hands and cut fingers off !
•
Never work without protection on the saw disc.
•
Before initial use, check the electrical data on the plate to see if they correspond to the mains electrical data.
• If an extension cable is used, mind that the wire for the stated supply is sufficient. Minimum diameter . 1.0 mm2.
•
Keep the bench and the workplace clean, remove the sawdust and things you do not use any more.
•
Watch out for places around the saw, where there is a risk of stumbling e.g. supply cable .
•
The person working with the unit should not be distracted if possible .
• Watch out for the motor and saw disc rotation direction. .
•
When the motor is switched off, never brake the disc with lateral pressure .
Required structural groups
Structural group 4
24
Delivered parts and
accessories
Fig. 1 – pos. 12
Fig. 1 – pos. 14
Fig. 1 – pos. 13
Fig. 1 – pos. 15