Güde TK 2400 ECO Mode D'emploi page 22

Operator Requirements
The operator shall read the instruction manual carefully before using the unit.
Qualification
No special qualification is required for use of the unit except for detailed direction by a professional.
Minimum Age
Only persons above 16 years of age are allowed to work with the unit. .
Exempted from the provision is the use of the juvenile trainees if they work in the course of their professional training with an aim to
obtain the skill under a trainer supervision.
Training
Use of the unit requires adequate lesson by a professional or the use of the manual only . Special training is not required.
Technical Data
Power connection
Frequency/Protection type
Max. output P
1
Motor speed
Saw disc
Cutting output at 90°
Cutting output at 45°
Bench size - width
Extension tables incl.
Bench size – depth
Bench size – height
Acoustic output level
Weight (approximate)
Ordering No.
Transportation and Storage
•
The unit should be cleaned thoroughly for longer storage .
•
Always push the disc in to prevent injuries .
• Protect the saw with a plastic sheet, cardboard etc. from weather effects .
Assembly and Initial Operation
Structural group 1
Fig. 3
The saw may be used without the base, on a table or a bench !
Structural group 3
TK 2400 ECO
230 V
50 Hz
1500 W/S6; 40 %
-1
5700 min
254 mm/30 mm/24 teeth
75 mm
60 mm
446 mm
946 mm
640 mm
850 mm
L 87,3 dB
WA
L 99,5 dB
PA
23 kg
55166
Required structural groups
Structural group 2
22
Delivered parts and
accessories
Fig. 1 – pos. 2/4 x
Fig. 1 – pos. 6/4 x
Fig. 1 – pos. 8/16 x
Fig. 1 – pos. 9/16 x
Fig. 1 – pos. 10/16 x
Delivered parts and
accessories
Fig. 1 – pos. 8/4 x
Fig. 1 – pos. 9/4 x
Fig. 1 – pos. 10/4 x
Make sure that the saw has
sunk and settled firmly. Fix
the saw and base with
screws .