Güde TK 2400 ECO Mode D'emploi page 27

Lengthwise Cutting
Fig. 12
Chamfer cuts
Cross Cutting
Fig. 14
•
•
•
•
•
•
•
•
Fig. 13
•
•
tightly, never cut a piece held loosely..
27
Set the parallel stop (Fig. 2/pos. 3) at
the required width in relation to the saw
disc. .
Lay the work on the bearing surface are,
the flatter/wider side should lay flat on
the saw bench.
Guide the wider work with hand, the
smaller one with use of a sliding guide
rod (Fig. 1/pos. 11).
Caution: Keep a large safety
distance from the saw disc.
Release the lock lever (Fig. 2/pos. 12)
and set the required angle on the rotary
wheel (Fig. 2/pos. 10)
Make sure that the splitting wedge
(Fig. 2/pos. 18) is always flushed with
the disc. .
Secure lock laver (Fig. 2/pos. 12) again
.
Chamfer cuts should be always done
using the parallel stop (Fig. 2/pos. 3).
Put the cross stop into one of two
grooves on the saw bench and set up
the required angle measure .
If the disc is to be adjusted at an angle
as well (see Fig. 15), a groove should
be used to prevent any contact of your
hand and of the cross stop with the disc
cover .
Caution: Hold the worked piece