Güde TK 2400 ECO Mode D'emploi page 26

Mitre cut stop
Fig. 8
Cutting Angle Setting
Fig. 9
Cutting depth set-up
Fig. 10
Unit On/Off switching
•
•
•
far in the direction of the saw disc! The
distance between the stop and the disc must
be 20 mm at least.
•
•
•
•
•
•
The unit is equipped with a lockable
overloading protection emergency switch.
An emergency switch is provided.
Fig. 11
26
Put the mitre cut stop (Fig. 2/pos. 14)
in the respective clamp on the bench.
Release the mitre cut stop (Fig. 2/pos.
14) with the knurled screw . Turn the
stop for the arrow to stop at a required
angle
Retighten the knurled screw
Caution: Do not move the stop too
It is possible to read the disc set-up 0°
- 45° from the scale (Fig 2/pos 7).
Loosening both the lock lever (Fig.
2/pos. 12) and turning the wheel Fig.
2/pos. 10), the disc inclination may be
changed.
Cutting depth may be set-up by turning
hand wheel (Fig. 2/pos. 9)
Turning had wheel to the left = smaller
cutting depth
Turning hand wheel to the right = bigger
cutting depth .
Press the green knob "I" to switch the
unit on.
To switch it off, press the red knob " 0".