Publicité
Les langues disponibles
Les langues disponibles
Inspections and Maintenance
Unplug the unit before any works on it.
•
Use a damp cloth to clean plastic parts. Do not use detergents, solvents and pointed things either.
•
Clean any dirt from the bench surface with a suitable curing compound spray.
•
If the engine braking time is more than 10 s, the fast wearable parts of the engine brake may be replaced by the manufacturer or
an appropriate workshop only.
•
Remove the dust stuck in the vent and on movable parts with a soft brush after every use.
•
Oil all the movable metal parts regularly.
Saw Disc Replacement
Caution! Switch the unit off and unplug before any maintenance, adjustment or replacement of the saw disc.
•
Turn the disc height readjusting wheel (Fig. 1/pos. 9) as far as to the upper stop .
•
Remove the disc protection cover (Fig. 2/pos. 1) .
•
Remove the bench removable part .
•
Take the splitting wedge out (Fig. 2/pos. 17).
•
Use a spanner to hold the spindle .
•
Use another spanner to loosen the disc screw . Turn anticlockwise (clockwise thread) .
•
Now, turn the height adjusting wheel (Fig. 2/pos. 9) as far as to the lower stop so that the disc
may be taken out easily. .
•
Put the disc from the hub and lift it up
•
Before putting in a new or sharpened disc, clean the hub carefully .
•
Putting in and securing a new disc should be done in reverse order.
•
Notice! Mind the correct direction of turning! The teeth cutting edge should point in the direction of
rotation i.e. forward. Mind the arrows on the disc and the protection cover !
•
Put back and straighten the splitting wedge (Fig. 2/pos. 17) and protection cover t (Fig. 2/pos. 1) .
•
Before using the saw again make sure that all the safety and protection devices work correctly.
•
Important! If you put on the disc again, turn it a little by hand and check to see that it turns freely. .
•
Afterwards, connect the unit and before using it, let it idle at first. .
Driving belt replacement
Open the bench liner, remove the splitting wedge n (Fig. 2/pos. 18) and exhaust hose (Fig. 2/pos. 15) and put the unit head up on the
bench. .
•
Fig. 19
•
Fig. 20
•
Fig. 21
29
Loosen the disc screw with wrench 24 anticlockwise while
holding the disc spindle with wrench 13.
Remove the saw disc .
Put the screwdriver behind the flat belt .
Fig. 18
Publicité
