Control Point; Checking The Settings; Operation; Standard Operation - SOMFY J4 RTS Notice Installateur

EN
Programming the first Somfy local control point
4.6.
4.6.1. Using a pre-programmed Somfy local control point
Briefly press the PROG button on this control
point: the E.V.B. moves briefly,
the control point has been programmed.
4.6.2. After a power cut
• Press the Up and Down buttons on the new
control point simultaneously until the blind moves.
• Briefly press the PROG button on this control
point: the E.V.B. moves briefly; the control point
has been programmed.

Checking the settings

4.7.
Check the settings of the upper and lower end limits using the Somfy local control point.
5. OPERATING

5.1. Standard operation

5.1.1. Favourite position (my)
Besides the upper and lower positions, an intermediate position known as the «favourite
position (my)» may be programmed in the motor. The "my" favourite position is pre-set in the
factory, and corresponds to the "slats lowered, sun protection" position.
To modify or delete the favourite position (my), see the section entitled «Modifying settings».
To use the favourite (my) position: Briefly press the «my»
button: the E.V.B. starts to move, then stops and angles
the slats in accordance with the angle programmed for the
favourite (my) position.
5.1.2. STOP function
The E.V.B. is moving.
Briefly press the «my» button: the E.V.B. stops
automatically.
78 Images not contractually binding
5072038D J4 RTS.indd 78
Copyright © 2013-2017 SOMFY ACTIVITES SA. All rights reserved.
31/05/2017 11:18:44