Identifi Cation - Gaspardo ALITALIA Emploi Et Entretien

ENGLISH
1.2 GUARANTEE
The guarantee is valid for a year, against all defects of material, from the date of delivery of the equipment.
On delivery, check that the equipment has not been damaged during transport and that the accessories are integral and complete.
POSSIBLE CLAIMS MUST BE PRESENTED IN WRITING WITHIN EIGHT DAYS OF RECEIPT.
The purchaser will enforce his rights on the guarantee only when he has respected the conditions concerning the benefi t of the gua-
rantee, set out in the supply contract.
1.2.1 EXPIRY OF GUARANTEE
Besides what has already been set out in the supply contract, the guarantee expires:
- If the limits set out in the technical data table are overshot.
- If the instructions set out in this booklet have not been carefully followed.
- If the equipment is used badly, defective maintenance or other errors by the client.
- If modifi cations have been carried out without written authorization of the manufacturer and if non original spare parts have been
used.
1.3 IDENTIFICATION
Each individual machine has an identifi cation plate (Fig. 1) indica-
ting the following details:
IDENTIFICATION PLATE FOR COMBINED MACHINE (A)
1) Trademark and address of the Manufacturer.
2) Combined machine type and model.
3) Unladen mass of the combined machine with harrow of greatest
mass, (kg).
4) Maximum working load of the combined machine, (kg).
5) Serial number of the combined machine.
6) Year of manufacture of the combined machine.
7) CE mark.
IDENTIFICATION PLATE FOR SEED DRILL (B)
1) Trademark and address of the Manufacturer.
2) Seed drill type and model.
3) Unladen mass of the seed drill, (kg).
4) Maximum working load of the seed drill, (kg).
5) Serial number of the seed drill.
6) Year of manufacture of the seed drill.
This information must always be quoted whenever assistance or
spare parts are needed.
You are advised to note down your data on the form below, along
with the date of purchase (8) and the dealer's name (9).
Date of purchase
_________________
Mass of the Rotating Harrow (*)
................................... ___________ +
Mass of the rear roller (*)
Unladen mass of the Seed Drill (**)
Unladen mass of the combined machine
Maximum load of the seed drill (**)
Fully laden mass of the combined machine
(*) see «Technical Data» in the power harrow instructions manual.
(**) see «Technical Data» in this instructions manual.
46 - EN
USE AND MAINTENANCE
Dealer
____________________
......................... ___________ +
.................... ___________ =
............ ___________ +
..................... ___________ =
........ ___________
(A)
(B)
fi g. 1
Do not remove, tamper with or make the CE mark affi xed on
Refer to the information provided on the CE mark for the
manufacturer's contact details (e.g. for requesting spare
When the machine is demolished, destroy the CE marking.

(1)
(2)
(4)
(3)
(5)
(6)
(7)
(1)
(2)
(4)
(3)
(5)
(6)
ATTENTION
the machine illegible.
parts, etc.).
cod. G19503391