Table des Matières
Publicité
GB
Check the grass catcher frequently for wear or
deterioration. After striking a foreign object. Inspect.
the lawnmower for damage and make repairs before
restarting and operating the equipment.
If the machine starts to vibrate abnormally, check
immediately.
TRANSPORTING
Ensure that the cutting units are in the transport
position. Do not transport with cutting mechanism
rotating.
Drive the machine with due consideration of road and
surface conditions, inclines and local undulations.
Sudden decelerating or braking can cause the rear
wheel to lift.
IMPORTANT: Transport speed is for use on good
surfaces only. Never select transport speed on
grass areas or uneven or unsurfaced roads or
tracks.
LEAVING THE DRIVING POSITION
Park the machine on level ground. Before leaving the
driving position, stop the engine and make sure all
moving parts are stationary. Apply brakes and
disengage all drives. Remove the starter key.
SLOPES
TAKE EXTRA CARE WHEN WORKING ON SLOPES
Local undulations and sinkage will change the general
slope. Avoid ground conditions which can cause the
machine to slide. Keep machine speeds low on slopes
and during tight turns.
Sudden decelerating or braking can cause the rear
wheels to lift. Remember there is no such thing as a
"safe" slope. Travel on grass slopes requires particular
care.
DO NOT USE ON SLOPES GREATER THAN 15°
The slope 15° was calculated using static stability
measurements according to the requirements of
EN 836.
IMPORTANT: When working on any slope set the
weight transfer to its maximum (+) setting.
IMPORTANT
Only lift the cutting units to the vertical position for
gateways, trailer / truck transport or storage purposes.
DO NOT lift the cutting units to the vertical
position on slopes.
GB-F-NL-6
Publicité
Table des Matières
