INSTALLATIoN
Troubleshooting
Signal anode with consumption indicator
Material losses
!
If the consumption indicator changes colour from white
to red, have the signal anode checked by a qualified con-
tractor and if necessary replaced.
1 White = Anode OK
2 Red
= Requires checking by qualified contractor
Scaling
Almost every type of water will deposit limescale at high temper-
atures. This settles inside the appliance and affects both perfor-
mance and service life. A qualified contractor who knows the local
water quality will tell you when the next service is due.
f Check the taps regularly. Limescale deposits at the tap out-
f
lets can be removed using commercially available descaling
agents.
f Regularly activate the safety valve to prevent it from becom-
f
ing blocked, e.g. by limescale deposits.
6.
Troubleshooting
Problem
Cause
The water does not heat
There is no power.
up. The heating does not
work.
If you cannot remedy the fault, contact your qualified contractor.
To facilitate and speed up your request, provide the number from
the type plate (000000-0000-000000).
www.stiebel-eltron.com
1
2
remedy
Check the fuses/MCBs in
your distribution board.
No.: 000000-0000-000000
Made in Germany
INSTALLATIoN
7.
Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1
General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
7.2
Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
8.
Appliance description
8.1
Standard delivery
The following are delivered with the appliance:
- 4 adjustable feet
8.2
Accessories
Required accessories
Safety assemblies and pressure reducing valves are available
to suit the prevailing supply pressure. These type-tested safety
assemblies protect the appliance against impermissible excess
pressure.
Additional accessories
- Pump assembly for a heating circuit with mixer HSBC-HKM
- Pressure hoses
- Water softening fitting HZEA
- Temperature sensor PT1000 for area cooling
HSBC 200 L |
25