Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATIoN
Preparation
9.2.2 Separating / joining the appliance sections
Separating the appliance sections
f Pull out the "heating sensor" at the buffer cylinder.
f
f Release the sensor leads from the guide groove in the insula-
f
tion segment.
f Disconnect the push-fit connectors of the 4 hydraulic con-
f
nections. To do this, pull the spring clips fully out with a
screwdriver.
f Pull the hydraulic connectors off forwards.
f
www.stiebel-eltron.com
f Remove the 4 hydraulic hoses and the insulation segment.
f
f Release the 4 screws on the tabs at the front of the appliance.
f
f Pull the upper section of the appliance towards the front.
f
HSBC 200 L |
27
Publicité
Chapitres
Table des Matières
Dépannage
