CoNTeNTS | SPeCIAL INforMATIoN
SPECIAL INFORMATION
OPERATION
1.
1.1
1.2
1.3
1.4
1.5
2.
Safety �������������������������������������������������������� 24
2.1
Intended use ����������������������������������������������������� 24
2.2
2.3
Test symbols ����������������������������������������������������� 24
3.
4.
5.
6.
7.
Safety �������������������������������������������������������� 25
7.1
7.2
8.
8.1
8.2
Accessories ������������������������������������������������������� 25
9.
Preparation ������������������������������������������������� 26
9.1
9.2
10.
Installation �������������������������������������������������� 29
10.1
10.2
10.3
10.4
11.
11.1
11.2
11.3
12.
12.1
12.2
13.
14.
Maintenance ������������������������������������������������ 35
15.
Specification ������������������������������������������������ 36
15.1
15.2
15.3
15.4
Data table �������������������������������������������������������� 39
ENVIRONMENT AND RECYCLING
22
| HSBC 200 L
SPeCIAL INforMATIoN
- The appliance may be used by children over
8 years of age and persons with reduced phys-
ical, sensory or mental capabilities or a lack of
experience and expertise, provided that they are
supervised or they have been instructed on how
to use the appliance safely and have understood
the potential risks. Children must never play with
the appliance. Children must never clean the ap-
pliance or perform user maintenance unless they
are supervised.
- The connection to the power supply must be in
the form of a permanent connection. Ensure the
appliance can be separated from the power sup-
ply by an isolator that disconnects all poles with
at least 3 mm contact separation.
- Observe all applicable national and regional reg-
ulations and instructions.
- Observe minimum distances (see chapter "Instal-
lation / Preparations / Installation site").
- Only a qualified contractor should carry out in-
stallation, commissioning, maintenance and re-
pair of the appliance.
DHW cylinder
- Drain the appliance as described in chapter "In-
stallation / Maintenance / Draining the DHW
cylinder".
- Observe the maximum permissible pressure (see
chapter "Installation / Specification / Data table").
- The appliance is pressurised. During the heat-up
process, expansion water will drip from the safety
valve.
- Regularly activate the safety valve to prevent
it from becoming blocked, e.g. by limescale
deposits.
- The safety valve drain aperture must remain open
to atmosphere.
www.stiebel-eltron.com