Correcting Wire Feed - Fronius VarioStar 1500 Instructions De Service

Correcting wire To ensure that the welding wire is transported properly, it must feed into the torch
feed without rubbing against the sides.
Fig.10 Non-permitted deviation
Note! The height can only be adjusted by Fronius After-Sales Service.
Spacers (10 x 0.1)
14
The wirefeed has been preset to obtain
the best results. If components are re-
placed, e.g. feed rollers, drive motor, etc,
a slight adjustment may be necessary.
The wirefeed can be adjusted by remo-
ving or adding spacers between the drive
roller and Seeger ring.