P3 Humid Mode - EOS EMOTEC HCS 9003 Instructions De Montage Et D'emploi

P3 Humid mode

For humidity operation adjustment please
press „Mode" button.
Afterwards the „ „ button until in the display
the humidity symbol and „P3" appears.
Please confi rm with the „Mode" button.
Please chose the wished value with the „
„ and „ „ buttons.
0 = Finnish operation
1 = Humidity operation
Please confirm with a long press on the
„Mode" button until the new value is fl ashing
on the display.
Afterwards the displays shows „P3" for
short
The default values are set to a temperature
of 60°C and a humidity of 60%.
Press the „ „ button to start the steam
operation mode.
If you programmed the unit while it was run-
ning, you must switch off and restart it using
the „ „ button.
After starting up, the display alternates bet-
ween the time of day, the remaining heating
time and the preset humidity level.
The display indicates increasing cabin tem-
perature through the rising thermometer,
until it has reached the arrow representing
the desired temperature.
58
P
20:03
05:58
GB
3
0
1
1
60