Switching On The Device For The First Time - EOS EMOTEC HCS 9003 Instructions De Montage Et D'emploi

Switching on the device for the
fi rst time
After checking all the connections once
again, connect the device to the mains by
switching on the fuses or mains switch.
The time appears on the display.
If the display fl ashes, proceed as follows:
Please chose the wished value with the „
„ and „ „ Please chose the wished value
with the
Please confi rm with the „Mode" button.
Afterwards the displays shows „F1" for
short time.
Afterwards the display shows the present
time. The unit is ready to use.
Refer to chapter „F1" of the operating in-
structions for information on changing the
time setting.
The device is switched on via the „ „ but-
ton. This also switches on the cubicle and
screen lighting.
On the display appears
20:03
12:03
20:03
20:03
20:03
06:00
GB
47