Please Note The Following When Programming The Unit - EOS EMOTEC HCS 9003 Instructions De Montage Et D'emploi

The sauna switches off automatically at the
end of the selected heating time.
If you want to end your sauna before this
time, press the „
switched off. The screen indicates the cur-
rent time.

Please note the following when programming the unit

The buttons to be used are shown in the text as follows.
Symbols shown in the display sketches as follows will fl ash on the
JEvery change to the set parameters must be confi rmed and saved by pressing the „Mode"
button. The new values set fl ash briefl y before the unit switches back to the basic display.
If you change the parameters without saving them with the „Mode" button, the previous
values automatically remain active.
If you do not operate the unit for a longer period when programming, the display switches
back automatically to the basic display, and the background lighting switches off after a short
time.
The many programming facilities of the unit are divided basically into:
Specialist levels
Programmierebenen
„ button. The sauna is
= „ „
= „ „
= „Mode"
MODE
= „ „
= „ „
These levels are indicated by „F 1 - F 6". Depending on the unit
type, it may be that certain individual levels are not displayed.
Parameters that only have to be changed very rarely in daily use
can be changed here. These are set following initial installation,
and then usually remain unchanged, at least for an extended pe-
riod.
These levels are indicated by „P 1 - P 9". Depending on the unit
type or the set operating mode, it may be that certain individual
levels are not displayed.
Parameters that are changed often to meet your individual require-
ments in daily use can be changed here.
20:03
GB
display.
49