Package Contents; Technical Data - EOS EMOTEC HCS 9003 Instructions De Montage Et D'emploi

Package contents

(subject to change)
Included with the control unit are:
1. An oven-sensor board with overheat shutoff protection, KTY-sensors with sensor housing
, two 3x25 mm fastening screws and a 1,7 m long sensor cable, red and white.
2. A plastic bag with three 4 x 20 mm fastening screws.
3. A replacement overheat protection module.

Technical data

Nominal voltage:
Switching load:
Heating time limit:
Display:
Protection class:
Normal range for sauna:
Normal range for humid mode:
With humidity-control
without humidity sensor:
Sensor system:
Water level monitoring:
Control characteristic:
Fan output:
Light:
Coloured light (optional):
Colour on-time:
Colour order:
-
Reheatingtime:
Error display:
Ambient temperatures:
Storage temperatures:
38
400 V 3 N AC 50 Hz
max. 9 kW Ohm resistive load (AC1 - mode)
Air conditioning mode: 6 kW + 3 kW for vaporiser device
can be extended by connecting powered control units
up to 36 kW
6 hr, 12 hr or no heating time limit
Jumbo backlit LCD
IPx4 in line with DIN 40050 splashed water resistant
30 to 110°C
30 to 70°C
me/proportional vaporizing control.
KTY sensor with safety temperature limiter 142°C
A lack of water in the vaporiser results in automatic shut
down after two minutes Lack of water.
digital two-point regulation
min. 25W max.100 W max. 500 mA (only fan excluding
capacitor)
min. 25W max.100 W max. 500 mA (only Ohm resistive
load)
Fuse protection on the light and the ventilation can be
a maximum of 0,5 A delay action. There is a danger
of fi re if greater fuse protection is used!
max. 100 W per colour
1 - 10 min
red - red/yellow - yellow - yellow/green - green - green/blue
blue - blue/red
0 - 60 min after switching off humidity program
via warning triangle (fl ashing) and error code on LCD
-10°C to +35°C
-20°C to +60°C
GB