VINCENT SV-122 Manuel D'utilisation page 59

A A c c t t i i o o n n
Choose the RDS tuner
as input source
Choose
frequency
band
Change between
stereo and mono
radio reception
Choose a station
by scanning the
frequency band
Choose a station
by entering the
numerical frequency
value
B B u u t t t t o o n n ( ( s s ) ) D D e e s s c c r r i i p p t t i i o o n n
I I N N P P U U T T
S S E E L L E E C C T T O O R R
To select the tuner push the „TUNER" button on the remote control or
( ( 9 9 ) ) use the „INPUT SELECTOR" at the front panel. On the remote control,
T T U U N N E E R R ( ( 2 2 4 4 ) ) the "SET" buttons can also be used to change to the "TUNER" input.
S S E E T T ( ( 3 3 8 8 ) )
Use these buttons, located at the front panel or on the remote control,
A A M M / / F F M M
to switch between AM and FM mode. FM offers better sound quality
( ( 8 8 ) ) ( ( 2 2 5 5 ) )
and a greater variety of radio stations.
This button, located at the front panel or on the remote control, enables
S S T T / / M M O O N N O O
or disables the mono reception. This could be useful if a radio station's
( ( 8 8 ) ) ( ( 2 2 7 7 ) )
signal is weak. Then sometimes the sound quality is better in mono.
With the tuner selected as input, press the button "TUNING MODE"
at the front panel or "TU.MODE" on the remote control to select of all
T T U U N N I I N N G G
three possible options one of the following two:
M M O O D D E E ( ( 8 8 ) )
• MANUAL stepping through the frequencies by steps of 50 kHz
T T U U . . M M O O D D E E
( ( 3 3 0 0 ) )
In this mode, the buttons
the buttons
manually through the frequency band. The display (2) shortly shows
T T U U N N I I N N G G
"TNR MANU".
P P R R E E S S E E T T ( ( 8 8 ) )
• AUTO
T T U U / / P P R R
In this mode, when the buttons
( ( 3 3 2 2 ) )
and the buttons
frequency scan is started, it stops at the next frequency with a strong
enough radio signal. The display (2) shortly shows "TNR AUTO".
D D I I R R E E C C T T
( ( 8 8 ) ) ( ( 2 2 8 8 ) )
Press the button "DIRECT" the receiver then waits for the input of a five
digit number (on the number pad) that represents the frequency with two
Z Z a a h h l l e e n n t t a a s s t t e e n n internal decimal places. If an invalid frequency is entered, "ERROR"
( ( 8 8 ) ) ( ( 2 2 6 6 ) )
appears in the display (2).
TUNER
(FM) and 9 kHz (AM) )
TUNING PRESET
TU/PR on the remote control can be used to step
automatic frequency scan
TUNING PRESET
TU/PR on the remote control are pressed, a
at the front panel and
at the front panel
Vincent
59