Am Loop Antenna - VINCENT SV-122 Manuel D'utilisation

12 13
15 16
12. ANTENNA: FM connector 75Ω
Connect a standard coaxial antenna cable
here. If there is no antenna wall outlet in the
room, an indoor aerial or the supplied FM
antenna wire can be utilized.

13. AM LOOP ANTENNA

Connect both cable ends of the loop antenna
here if you want to listen to AM broadcast.
14. DIGITAL IN: audio connectors for devi-
ces providing a digital audio signal,
for example DVD-Players. „OPTICAL" is used for
TOSLINK digital connection and „COAXIAL" for
electrical connection using a coaxial cable.
15. 2 CH INPUTS: terminal with connectors
for audio signals of the source devices
that provide analog stereo audio signal
(for example CD-Players, video recorders).
16. 5.1 CH INPUT: connection terminal for
the audio signal of a source device
that provides analog multi channel
audio signal (for example an SACD-Player
or digital TV receiver)
17. OUTPUT „REC": connectors dedicated
to a stereo audio recording device (RCA)
If desired, connect for example an audio recor-
ding device (CD-recorder, tape recorder etc.).
The unchanged front audio signals (L,R) of the se-
lected input source device are supplied here.
Vincent
40
REAR VIEW:
14 17 20
18 19
22
21
18. OUTPUT „SW": pre-amplifier output
signal for the subwoofer
Connect an active subwoofer here if you want
to use one.
19. OUTPUT „PRE": pre-amplifier output
If desired, one additional stereo main amplifier
or two mono main amplifiers can be connected
here. The pre-amplified front audio signals (L,R)
of the selected input source device are availa-
ble at these connectors.
20. VIDEO INPUTS: input connectors for
video signals of the source devices
(for example a DVD-Player)
21. VIDEO OUTPUT: connection providing
the video signal to the displaying
device
(for example TV, video beamer)
22. SPEAKERS: screw terminals
Output connectors for front, center and surround
speakers as well as one passive subwoofer.
4mm banana plugs can be utilized at the
speaker cable.
23. AC power connector and fuse holder
To establish the power supply, connect the plugs
of the power cable to the device and to a 230V
AC wall outlet. The small plastic housing beneath
the plug opening holds the fuse. Refer to the
security precautions.
23