Remote Control - VINCENT SV-122 Manuel D'utilisation

Point the diode side of the remote set to the front
panel of the receiver, make sure there are no
objects between the remote set and the device.
Keep the distance between remote set and device
REMARKS ABOUT HANDLING OF THE REMOTE CONTROL
Usage of battery cells
Incorrect handling of the batteries can cause acid
leakage or in extreme cases explosion. The cells
must be inserted respecting the correct polarity as
seen on the plan inside the battery housing. For
longlife operation do not mix old batteries and
new ones and use the same battery type (for exam-
ple alcaline). Some battery cells are rechargable,
some are not. Refer to the details written on the cell
surface. Remove batteries when not using the
remote control for an extended period. Batteries
must never be short-circuited, disassembled or
exposed to heat! Used batteries are hazardous
waste and must be disposed of according to local
regulations. Do not put them into household waste.
Use micro AAA cells (LR3) only.

REMOTE CONTROL

less than 7 meters. Do not point from an angle
greater than 30 degrees from the middle axis.
Change the batteries when the distance of reliable
operation is shortening.
Replacing of the batteries:
a. Open and remove the plastic cover on the
b. Remove used cells and insert new ones as
c. Close the cover.
backside of the remote.
seen on the scheme inside.
Neu
Alt
a
b
c
Vincent
41