Speaker Settings; Button(S) Function - VINCENT SV-122 Manuel D'utilisation

Home cinema systems are designed for a variety of combinations with other consumer electronics and many dif-
ferent environments. That is why it is necessary to configure the system before first use and everytime the speaker
system is changed.
Usually, a quick setup procedure must be absolved, where audio/video settings have to be made. This setup has
been reduced to the minimum required steps at this receiver, to kepp it user friendly. No video settings have to be
taken on for this receiver. So only the speaker configuration and the required volume differences and delay times
have to be defined. Note that some settings can only be made using the remote control.
It is best to follow the sequence displayed in the following table:
Button(s) Function
Speaker configuration
1 SPEAKER
(6)(39)
Stereo bal. and vol. level difference of center,
2 CHANNEL
surround and subwoofer signals in relation to
(5)(36)
front channel volume level
The speaker channel test sound („TEST" (47))
TEST (47)
can make volume level differences experienced
at the listening position recognizable
Delay times of the center and surround signals
3 DELAY (42)
in relation to front channel signal
Vincent
52

SPEAKER SETTINGS

At front panel/with
remote control
both
both
remote control only
remote control only
available
parameters
SMALL
LARGE
NONE
Speaker channel
volume differences
in dB
Delay time in ms
(milliseconds)