VINCENT SV-122 Manuel D'utilisation page 42

BUTTONS REMOTE CONTROL
24. Buttons for input channel selection
These buttons choose the desired input source
(device connected to CD, AUX1, AUX2, 5.1CH,
OPTICAL, COAXIAL (14)(15)(16) or the built-in
TUNER) that you want to change to.
25. AM, FM If the receiver input "TUNER" has
been chosen, this button switches between AM
and FM mode. A suitable antenna must be
connected to the corresponding antenna input
(12)(13).
26. Number block for the control of the Tuner
Number pad (0-9) for direct frequency input or
selection of presets in Tuner mode.
27. ST/MONO
been chosen, you can switch between stereo
and mono reception of radio stations. If a station's
signal quality ls low in stereo mode, a change to
mono mode may result in better sound quality.
28. DIRECT If the Tuner has been selected as input
source, after pushing this button you can enter a
known radio station frequency directly by using
the number buttons (26).
29. MEMORY If the receiver input "TUNER" has
been chosen, this button is used to store a previo-
usly selected radio station fequency to one of the
memory presets. The procedure is described in
the chapter „Operating the receiver - Tuner".
30. TU.MODE If the Tuner has been selected as
input source, you can use this button to choose
between three settings that determine what functi-
on the buttons
„MANUAL" (manuel frequency scan), „AUTO"
(automatic frequency scan) oder „PRESET"
(search the tuner preset stations stored previously).
31. A.MUTE If the receiver input "TUNER" has
been chosen, a volume muting that will be
applied in manual tuning mode can be activated
or deactivated using this button. It removes the
noise at frequencies between the stations.
Vincent
42
If the receiver input "TUNER" has
TU/PR (32) will have:
24
26
28
30
34
36
38
41
42
44
46
VRC-12
32. TU/PR If the receiver input is set to
„TUNER", you can select a radio station with these
buttons. What function they will have is deter-
mined by the setting that has been done by
pressing „TU.MODE" (30).
33. RDS If the receiver input "TUNER" has been
chosen, this button activates, deactivates and
changes the different possible RDS services.
RDS is available from some FM radio stations
and provides the listener with text information
seen in the front panel display (2).
34. PROLOGIC, 3-ST, STEREO These three audio
playback modes (D. Prologic, 3-Stereo, Stereo), based
on the stereo format, are also selectable using the
„LISTEN"-button (37) and can be directly chosen here.
25
27
29
33
31
35
32
37
39
40
43
45
48
47